|
1. Clear a large area to work and lay down a sheet or two of protective paper. To keep the tie clear from any unwanted accidents or smudges, mask the perimeter of the tie with sticky notes. Leave open the section around the image area for stamping.
2. Cut a sponge with scissors into a few 1” square sections. Each piece of sponge will be used for each different color.
3. Pour small amounts of paint onto the paper plates. Allow for two colors per plate which will leave plenty of room for blotting.
4. Pick-up color with a sponge and blot off excess paint by dabbing it on a clean area of the plate. Apply inked sponge to the flower stamp.
5. Stamp onto the fabric being careful not to press too hard or rock the stamp. Repeat and change flower and color as desired.
6. Allow to dry over night, and then heat set. |